Free Shipping Over $119



Yahboom Biped:bit Robot course 2.1 Advance

Posted by SuFiona on

Buy Yahboom Biped:bit Robot course 2.1 Advance

1.Learning goals

In this lesson, we mainly learn how to control building block motor by micro:bit and Super:bit expansion board.

2.Programming method

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom packagehttps://github.com/lzty634158/SuperBit to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package:

https://github.com/lzty634158/SuperBit, you can program.

3.Looking for blocks

The following is the location of the building blocks required for this programming.

image.png

image.png 

4.Combine building block

The summary program is shown below:

image.png 5.Assembly steps

Please refer to Assembly instructions folder for building blocks assembly steps.

6.About wiring:

As shown below,

building block motor connect to M1 interface of super:bit.

image.png 

7. Experimental phenomena

After the program is successfully downloaded, the micro:bit dot matrix will display thesmile pattern and the car will advance.

The code of the experiment:  1.Advance.rar

0 comments

Leave a comment

Please note, comments must be approved before they are published