5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10

Yahboom Biped:bit Robot course 2.2 Button control robot

Posted by SuFiona on

Yahboom Biped:bit Robot course 2.2 Button control robot

1.Learning goals

In this lesson, we mainly learn how to control building block motor by micro:bit and Super:bit expansion board. 

2.Programming method

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom packagehttps://github.com/lzty634158/SuperBit to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package:

https://github.com/lzty634158/SuperBit, you can program. 

3.Looking for blocks

The following is the location of the building blocks required for this programming.




4.Combine building block

The summary program is shown below:


5.Assembly steps

Please refer to Assembly instructions folder for building blocks assembly steps.

6.About wiring:

As shown below,

building block motor connect to M1 interface of super:bit.

image.png7. Experimental phenomena

After the program is successfully downloaded, the micro:bit dot matrix will display thesmile pattern and the robot will stop, when we press the A button, the robot will advance, when we press the B button, the robot will back.

The code of the experiment:2.Button control robot.rar


Leave a comment

Please note, comments must be approved before they are published