Spring Sale: 5% OFF Over $89, Code: Elephant5; 10% OFF Over $149, Code:Elephant10

Yahboom Biped:bit Robot course 2.5 Dancing

Posted by SuFiona on

Yahboom Biped:bit Robot course 2.5 Dancing

1.Learning goals

In this lesson, we mainly learn how to control building block motor and RGB lights by micro:bit and Super:bit expansion board. 

2.Programming method

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom packagehttps://github.com/lzty634158/SuperBit to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package:

https://github.com/lzty634158/SuperBit, you can program. 

3.Looking for blocks

The following is the location of the building blocks required for this programming.







4.Combine building block

The summary program is shown below:


5.Assembly steps

Please refer to Assembly instructions folder for building blocks assembly steps.

6.About wiring:

As shown below,

building block motor connect to M1 interface of super:bit.

image.png7. Experimental phenomena

After the program is successfully downloaded, the micro:bit dot matrix will display the smile pattern and the robot will play birthdayRobot will advance 3s, back 6s, advance 3s. And keep the loop in this state.

 The code of the experiment: 5.Dancing.rar


Leave a comment

Please note, comments must be approved before they are published