Summer Sale: 5% OFF Over $49, Code: Elephant5; 10% OFF Over $99, Code:Elephant10



Yahboom Omibox Robot Kit arduino IDE course 5.6 Sing

Posted by Fiona Su on

Yahboom Omibox Robot Kit arduino IDE course 5.6 Sing

1.Learning goals

1-1.The position of the Buzzer on the robot car

1-2.Learn about the Arduino board pins connected to the Buzzer of  Omibox programmable robot

2.Preparation

image.png

As shown in the above picture, we circled the buzzer with a red wire frame. We can control it play different tone by programming.

According to the hardware manual, we can see that the RGB light is connected to the Pin6 of the Arduino, so you can control the state of the RGB light by controlling the Pin6 during programming.

3.About code 

The part code for this experiment is as follows:

image.png

image.png

4.Download code

1.We need to open the code of this experiment: sing.ino, click“√” under the menu bar to compile the code, and wait for the word "Done compiling " in the lower right corner, as shown in the figure below.

2. Click 【Tools】 --- 【Board】 -- we need to choose Arduino Uno. As shown in the figure below.

image.png

image.png

3.In the menu bar of Arduino IDE, we need to select 【Tools】---【Port】--- selecting the port that the serial number displayed by the device manager, as shown in the figure below.

4. After the selection is completed, you need to click “ →  ”under the menu bar to upload the code to the Arduino UNO board. When the word “Done uploading” appears in the lower left corner, the code has been successfully uploaded to the Arduino UNO board, as shown in the figure below.

image.png

image.png

5.Experimental phenomena

After the program is uploaded, turn on the power of the car, two Music patterns will be displayed on the dot matrix, and the buzzer will play the song "Ode ".

image.png

The code of the experiment: 6.Sing.rar

0 comments

Leave a comment

Please note, comments must be approved before they are published