5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10



Yahboom Omibox Robot Kit Remote control course 6.2 Expand IR control

Posted by Fiona Su on

Yahboom Omibox Robot Kit Remote control course 6.2 Expand IR control

1.Preparation

1-1.The position of the Infrared receiver on the robot car

1-2.Learn how to use  infrared remote control 

image.pngimage.png

As shown on the left figure above, the infrared receiver on the Omibox programmable robot circled by the red wire frame on the left. 

As shown on the right figure above, infrared remote controller.

The infrared remote controller is used to send a signal to the infrared receiver, and the infrared receiver is used to receive the signal sent by the infrared remote controller.

2.Learning goals

In this lesson, we mainly learn how to make the infrared remote controller to control the following functions of the Omibox programmable robot by programming.

image.png

3.Search for blocks

The following is the location of the building blocks required for this programming.

image.pngimage.pngimage.pngimage.pngimage.png

4.Combine blocks

Please see the Expand IR control.sb3 file for this experimental procedure.

5.Experimental phenomena

After the program is uploaded, open the power of the car, the infrared remote controller corresponds to the following functions.       

image.png

The code of the experiment: 2.Expand IR control.rar

 

0 comments

Leave a comment

Please note, comments must be approved before they are published