5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10



Omibox Robot Kit Wrestle Omibox Course 8.1.Button control

Posted by Fiona Su on

Omibox Robot Kit Wrestle Omibox Course 8A1.Button control Wrestle Omibox

1.Preparation

1-1. The position of the button in the robot car

1-2. Learn how to control buttons by graphically programming

image.png

As shown in the figure above,we circled the blue wire frame with two buttons, and we can control them by programming.

2.Learning goals

In this lesson, we will learn how to use the buttons. 

When the red button is pressed, right hand of wrestle Omibox will lift up .

When the red button is not pressed, right hand of wrestle Omibox will put down.

When the green button is pressed, left hand of wrestle Omibox will lift up.

When the green button is not pressed, left hand of wrestle Omibox will put down.

3.Search for blocks

The following is the location of the building blocks required for this programming.

image.png

image.png

image.png

image.png

image.png

4. Combine blocks

The summary program is shown below:

image.png

5.Experimental phenomena

!!!Note: When use servo in the first time,we need to remove the gear on the building block servo.Then, download the program to micro:bit. Next, turn on the power of the robot and wait for the building block servo to turn to the initial position and turn off the power. Finally, we need to install the gear on the building block servo.  Left hand and right hand will put down, in initial status.

Open the power of Wrestle Omibox, 

When the green button is pressed, Omibox start to attack.

When the green button is not pressed, Omibox recover . 

The code of the experiment: 1.Button control Wrestle Omibox.rar

0 comments

Leave a comment

Please note, comments must be approved before they are published