5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10



Defense Omibox ReadMe

Posted by Fiona Su on

!!!Note:

When use servo in the first time,we need to remove the gear on the building block servo and download the program to Omibox robot. Next, turn on the power of the robot, wait for the building block servo to turn to the initial position. Then, turn off the power. Finally, we need to install the gear on the building block servo.   

In initial status, shield is put down. As shown below.

image.png 

About wiring:

Servo connect to S1 interface of PCB board.

image.png 

image.png 

0 comments

Leave a comment

Please note, comments must be approved before they are published