Free Shipping Over $119



Balanced Robot Tutorial - 3.1 Battery of Arduino Balance use precautions

Posted by Fiona Su on

Last Tutorial >> 2.2 Arduino Compile tools

Battery of Arduino Balance Car use precautions:

1. Please use the charger we provide to charge the car.

2. The car cannot be used while charging.

3. The voltage needs to be charged in time at around 9V. When the charging is completed, the battery voltage is about 12.6V.

4. If you do not use the car for a long time, you should unplug the battery cable from the bottom plate of the car. Because even if the car is in standby, the battery will be worn out.

5.If you have not used the car for a long time, you need to fully charge the battery before using it next time, then use the car.

6.When the battery is charging, the charger indicator lights up red,the indicator will turn green after charging is complete.After charging is completed, the charger and power supply should be unplugged in time to avoid overcharging and damaging the battery.

7.The charging port of the car is on the bottom plate, not on the UNO board. The charger needs to be plugged into the bottom plate to charge. If the charger is plugged into the UNO board, the car cannot be charged.

The charging method is as shown below:

image.png 

image.png 

image.png 

Shop Yahboom Balance Robot Car Compatible with Arduino Programmable Kit Now!

0 comments

Leave a comment

Please note, comments must be approved before they are published