Summer Sale: 5% OFF Over $49, Code: Elephant5; 10% OFF Over $99, Code:Elephant10



Croco:kit sensor starter kit for micro:bit Tutorial 3.5 Rocker control

Posted by Fiona Su on

Croco:kit sensor starter kit for micro:bit Tutorial 3.5 Rocker control

1.Learning goals

After downloading the program, we can see a “Heart” on the Micro:bit LED dot matrix. When the rocker module is up, the up arrow is displayed on the LED dot matrix, When the rocker module is down, the down arrow is displayed on the LED dot matrix, 

When the rocker module is left, the left arrow is displayed on the LED dot matrix, 

When the rocker module is right, the right arrow is displayed on the LED dot matrix.

image.png

2.Preparation

Hardware:

  • 1 X Micro: bit Board
  • 1 X Micro USB Cable
  • 1 X Diamond breakout 
  • 1 X Rocker module
  • 4 X Alligator clip
  • 1 X PC

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package: https://github.com/lzty634158/Croco-Kit to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package: https://github.com/lzty634158/Croco-Kit , you can program.

image.png

!Note: S1 be set  to the ON, S2 be set  to the IO, and S3 to the NC.

3.Connection

image.png

image.png

4. Search for blocks

image.png

image.png

image.png

5. Combine blocks

image.png

image.png

The code of the experiment:  13.Rocker control.rar

0 comments

Leave a comment

Please note, comments must be approved before they are published