5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10



Croco:kit sensor starter kit for micro:bit Tutorial 4.12 Remote control handle

Posted by Fiona Su on

Croco:kit sensor starter kit for micro:bit Tutorial 4.12 Remote control handle

1.Learning goals

 After downloading the program, you can see that the micro:bit LED dot matrix display a “heart”. 

When the handle is up, down, left and right, the corresponding direction is displayed on the micro:bit LED dot matrix. When the red button is pressed, micro:bit LED dot matrix display “R” ; When the green button is pressed, micro:bit LED dot matrix display “G” .

image.png

2.Preparation

Hardware:

  • 1 X Micro:bit Board
  • 1 X Micro USB Cable
  • 1 X Diamond breakout 
  • 10 X Alligator clip
  • 2 X Rocker module
  • 1 X Button module
  • 1 X PC

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package: https://github.com/lzty634158/Croco-Kit to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package: https://github.com/lzty634158/Croco-Kit , you can program.

image.png

!Note: S1 be set  to the ON, S2 be set  to the IO, and S3 to the FM.

3.Connection

image.png

image.png

4. Search for blocks

image.png

image.png

image.png

5. Combine blocks

image.png

The code of the experiment:  34.Remote control handle.rar

Buy Yahboom Croco:kit sensor starter kit for micro:bit

Tutorial

0 comments

Leave a comment

Please note, comments must be approved before they are published