5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10



Croco:kit sensor starter kit for micro:bit Tutorial 4.13 Fingertip music

Posted by Fiona Su on

Croco:kit sensor starter kit for micro:bit Tutorial 4.13 Fingertip music

1.Learning goals

 After downloading the program, when we gently use the finger to gently shake the sensor on the vibration module, it will detect the vibration. At this time, the micro:bit dot matrix will display music pattern and  flash three times, and then the buzzer will play music, the blue RGB light will flash during music playing.

image.png

2.Preparation

Hardware: 

  • 1 X Micro:bit Board
  • 1 X Micro USB Cable
  • 1 X Diamond breakout 
  • 4 X Alligator clip
  • 1 X Servo
  • 1 X PC

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package: https://github.com/lzty634158/Croco-Kit to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package: https://github.com/lzty634158/Croco-Kit , you can program.

image.png

!Note: S1 be set  to the ON, S2 be set  to the IO, and S3 to the FM.

3.Connection

image.png

image.png

4. Search for blocks

image.png

image.png

image.png

image.png

image.png

image.png

image.png

image.png

image.png

5. Combine blocks

image.png

The code of the experiment:  35.Fingertip music.rar

Buy Yahboom Croco:kit sensor starter kit for micro:bit

Tutorial

0 comments

Leave a comment

Please note, comments must be approved before they are published