5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10



Tumble:bit based on Micro:bit Tutorial 2.4 Control motor

Posted by Fiona Su on

Tumble:bit based on Micro:bit Tutorial 2.4 Control motor

microbit-Contorl-motor.hex.zip

1.Learning goals

In this lesson, we mainly learn how to control motor by micro:bit and Super:bit expansion board.

2.Programming method

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package https://github.com/lzty634158/SuperBit to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package:

https://github.com/lzty634158/SuperBit, you can program.

3.Looking for blocks

The following is the location of the building blocks required for this programming.

image.png 

image.png 

4.Combine building block

The summary program is shown below:

Control one motor

image.png

Control four motor:

image.png                                                           

5. Experimental phenomena

After the program is successfully downloaded, the micro:bit dot matrix will display the heart pattern and control the 180° servo rotation.

The motor forward speed is 255->stop->reverse speed is 255, the time interval is 1 second, and the loop is kept in such a state.

If you need to start over, press the reset button on the back of the micro:bit board.

Tutorial

Tumble:bit Tutorial Overview

Buy Yahboom programmable Tumble:bit based on Micro:bit compatible with LEGO

0 comments

Leave a comment

Please note, comments must be approved before they are published