10% Off For Your First Order, Code:Elephant10



Tumble:bit based on Micro:bit Tutorial 3.1 Advance and back

Posted by Fiona Su on

Tumble:bit based on Micro:bit Tutorial 3.1 Advance and back

microbit-Tumblebit-Advance-and-back.hex

1. Learning goals

In this lesson, we will learn to use the micro:bit and Super:bit to control the building blocks to balance the car movement, including forward and back functions.

2.Programming method

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package https://github.com/lzty634158/SuperBit to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package:

https://github.com/lzty634158/SuperBit, you can program.

3.Assembly steps

Please refer to the  [Tumblebit Assembly Steps]

 

4.About wiring

The motor wiring on the left side of the building block balance car is connected to the Super:bit M1 interface, and the black wire is on the battery side.

The motor wiring on the right side of the building block balance car is connected to the Super:bit M3 interface, and the black wire is on the battery side.

As shown below:

image.png 

5.Looking for blocks

The following is the location of the building blocks required for this programming.

image.png 

image.png 

6.Combine building block

The summary program is shown below:

image.png 

7. Experimental phenomenon

After the program is successfully downloaded, the micro:bit dot matrix will show the smile. 

The building block balance car moves forward with 255 speed for 1 second, then, stops for 0.5 seconds,. Next, it moves back with 255 speed for 1 second, stops for 0.5 seconds. 

It will keep loop with this status.

If you need to restart, please press the reset button on the back of the micro:bit board.

Tutorial

Tumble:bit Tutorial Overview

    Buy Yahboom programmable Tumble:bit based on Micro:bit compatible with LEGO

    0 comments

    Leave a comment

    Please note, comments must be approved before they are published