5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10



Arduino Mega 2560 Project 7: Digital Tilt Sensor

Posted by Fiona Su on

Introduction
Tilt Sensor is a digital tilt switch. It can be used as a simple tilt sensor. Simplly plug it to our IO/Sensor shield; you can make amazing interactive projects. With dedicated sensor shield and Arduino, you can achieve interesting and interactive work.
Specification

  • Supply Voltage: 3.3V to 5V
  • Interface: Digital
  • Size: 30*20mm
  • Weight: 3g


Connection Diagram:

thumb

Sample Code:

int ledPin = 13;                // Connect LED to pin 13
int switcher = 3;                 // Connect Tilt sensor to Pin3
 
void setup()
{
  pinMode(ledPin, OUTPUT);      // Set digital pin 13 to output mode
  pinMode(switcher, INPUT);       // Set digital pin 3 to input mode
}
void loop()
{
     
   if(digitalRead(switcher)==HIGH) //Read sensor value
     { 
        digitalWrite(ledPin, HIGH);   // Turn on LED when the sensor is tilted
     }
   else
     {
        digitalWrite(ledPin, LOW);    // Turn off LED when the sensor is not triggered
     }
}

Project List

Buy it here>>Sensor Starter Kit For Arduino Mega 2560

0 comments

Leave a comment

Please note, comments must be approved before they are published