5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10

Arduino Project: Water Sensor

Posted by Fiona Su on



Our water sensor is easy- to-use, portable and cost-effective, designed to identify and detect water level and water drop. This sensor measures the volume of water drop and water quantity through an array of traces of exposed parallel wires. Compared with its competitors, this sensor is not only smaller and smarter but also ingeniously equipped with following features:

i)smooth conversion between water quantity and analog quantity;
ii)strong flexibility, this sensor outputs basic analog value;
iii)low power consumption and high sensitivity;
iv)directly connected to microprocessor or other logic circuits, suitable for a variety of development boards and controllers such as Arduino controller, STC single-chip microcomputer, AVR single-chip microcomputer etc.


  • Product name: Water Sensor
  • Operating voltage: DC5V
  • Operating current: ﹤20mA
  • Sensor type: Analog
  • Detection area: 40mm x16mm
  • Production process: FR4 double-side tinned
  • Humanized design: Anti-slippery semi-lunar recess
  • Operating temperature: 10%~90% without condensation
  • Product weight: 3g
  • Product size: 65mm x 20mm x 8mm

Connection Diagram


Sample Code

    int analogPin = 0; //connect water sensor to analog interface 0
int led = 13; //LED to digital interface 13 
int val = 0; //define the initial value of variable ‘val’ as 0
int data = 0; //define the initial value of variable ‘data’ as 0 
void setup()
pinMode(led, OUTPUT); //define led as output pin
Serial.begin(9600); //set baud rate at 9600
void loop()
val = analogRead(analogPin); //read and assign analog value to variable ’val’
if(val>700){ //decide whether variable ‘val’ is over 700 digitalWrite(led,HIGH); //turn on  LED when variable ‘val’ is over 700
digitalWrite(led,LOW); //turn off LED when variable ‘val’ is under 700
data = val; //variable ’val’ assigns value to variable ‘data’
Serial.println(data); //print variable ‘data’ by Serial.print



Leave a comment

Please note, comments must be approved before they are published