5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10

Robot Kit for Micro:bit Tutorial 5.1 Advance

Posted by Fiona Su on

Robot Kit for Micro:bit Tutorial 5.1 Advance


1-1.The position of the motor on the robot car

Programming method:

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package: https://github.com/lzty634158/Tiny-bit to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package: https://github.com/lzty634158/Tiny-bit, you can program.

As shown in the figure below, the red arrow points to the Tiny-bit motor.

2.Learning goal

2-1.Learn how to use control motor graphically program building blocks

2-2.In this lesson, we will make robot car advance.

3.Search for block

The following is the location of the building blocks required for this programming.

4.Combine block

The summary program is shown below:

5.Experimental phenomena

After the program is downloaded, we can see that the robot car will advance.

The code of the experiment:  1.Advance.rar

Running with Tiny bit Microbit Robot Tutorial:


Leave a comment

Please note, comments must be approved before they are published