Spring Sale: 5% OFF Over $89, Code: Elephant5; 10% OFF Over $149, Code:Elephant10



Tutorial — balanced robot

Balanced Robot Tutorial - 3.1 Battery of Arduino Balance use precautions

Posted by Fiona Su on

Last Tutorial >> 2.2 Arduino Compile tools Battery of Arduino Balance Car use precautions: 1. Please use the charger we provide to charge the car. 2. The car cannot be used while charging. 3. The voltage needs to be charged in time at around 9V. When the charging is completed, the battery voltage is about 12.6V. 4. If you do not use the car for a long time, you should unplug the battery cable from the bottom plate of the car. Because even if the car is in standby, the battery will be worn out. 5.If you have not used the car for a...

Read more →


Balanced Robot Arduino IDE Programming Tutorial-2.2 Arduino Compile tools

Posted by Fiona Su on

The Last Tutorial>> 2.1 Uart drive(CH340 The next Tutorial >> 3.1 Battery of Arduino Balance use precautions Installation instructions of Arduino IDE is shown in the following picture: 1.Open setup package to find arduino-1.7.8.org-windows.exe.   2.Double click to open the installation package arduino-1.7.8.org-windows.exe.   3.Click I Agree.   3. According to the default tick installation.   4. Select the installation directory.   5.Wait for the progress bar to complete,and operate as shown in the following figure.       After the steps above, the  Arduino IDE is successfully installed. --------------------------------------------------------------------------------------------------------------------- Use instructions of Arduino IDE is shown in the following picture: 1.Double click to open the Arduino software...

Read more →


Balanced Robot Arduino IDE Programming Tutorial-2.1 Uart drive(CH340)

Posted by Fiona Su on

Last Tutorial >> Bluetooth remote control operation Next Tutorial >> 2.2 Arduino Compile tools Drive installation method as shown in the following picture: 1. Open the installation package: Uart drive(CH340).   2. Double click to CH341SER.EXE   3.Double click to “INSTALL”   4.When appears to “The drive is successfully Pre-installled in adavnce”, that means that the driver has been installed, as shown in the following figure.   Shop Yahboom Balance Robot Car Compatible with Arduino Programmable Kit Now!

Read more →


Balanced Robot Tutorial-Bluetooth remote control operation

Posted by Fiona Su on

Balanced Robot Tutorial-Bluetooth remote control operation 1.turn on the balance car to ensure that the HC-06 bluetooth module is powered normally (the bluetooth module indicator is flashing)2.Mobile phone setting. Find HC-06 Bluetooth device (98:xx:xx:xx), click to enter the password 0000 or 1234 (currently only supports android phones) 3. open the mobile app to enter the APP interface, select the “bluetooth scan”, select the HC-06 bluetooth module just connected with physical address(98:xx:xx:xx). click the “connect” and wait for connection successful (at this time, the indicator of the bluetooth module is always on), then you can start the control. 4. in the...

Read more →


Welcome to Yahboom Arduino Balance Car Tutorial

Posted by Fiona Su on

Self Balance robot is a stable, rugged and durable two-wheel balance vehicle. We optimized the balancer algorithm, and the excellent software algorithm makes Arduino UNO as the core controller of the balance car. The car is a three-layer structure with a load capacity of more than 2KG. We adopt simple and clear modular design, which is suitable for balance car beginners. Arduino UNO board can be taken down easily for secondary development. Bluetooth remote control operation 2.Arduino IDE Programming 2.1 Uart drive(CH340 2.2 Arduino Compile tools 3.Battery and charging 3.1 Battery of Arduino Balance use precautions Download APP Code SCH...

Read more →