5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10



MQ-135 MQ135 air quality detection sensor module

Sale price $2.90 Regular price $4.76

Shipping calculated at checkout.

Introduction

Sensitive material MQ135 gas sensor is used in clean air low conductivity tin oxide (SnO2). When the sensor is kept in their environment In the polluting gases , the conductivity sensor with increasing air pollution in gas concentration increases. Using a simple circuit can change the conductivity Conversion of an output signal corresponding to the gas concentration.

MQ135 sensor for ammonia, sulfide , benzene vapor high sensitivity of the smoke and other harmful monitor is also very good. This sensor can be seized Measure a variety of harmful gases , is a low-cost sensors for a variety of applications .

Module Applications

Suitable for domestic or industrial hydrogen leak on a monitoring device. Are not subject to ethanol vapor, soot, carbon monoxide and other gases interference.

Features

1, the use of high-quality double-panel design, with power indicator and TTL signal output instructions;
2, with DO switch signal (TTL) output and AO analog signal output;
3, TTL output valid signal is low. (When the output low signal lights, can be directly connected to the microcontroller or relay module)
4, the analog output voltage with the higher the higher the voltage the higher the voltage.
5, the liquefied petroleum gas, natural gas, city gas, smoke has a better sensitivity.
6, there are four screw holes to facilitate positioning;
7, product dimensions: 32 (L) * 20 (W) * 22 (H)
8, with long service life and reliable stability
9, fast response to recovery features

Electrical performance

Input voltage: DC5V Power consumption (current): 150mA
DO output: TTL digital 0 and 1 (0.1 and 5V)
AO output: 0.1-0.3V (relatively no pollution), the maximum concentration of about 4V voltage
Special reminder: the sensor power, the need to preheat 20S or so, the measured data was stable, the sensor fever is a normal phenomenon, because the internal electric wire, if the hot is not normal.
Wiring:
1, VCC: then the power supply positive (5V)
2, GND: Connect the power supply negative
3, DO: TTL switch signal output
4, AO: analog signal output