5% OFF Over $19, Code: Elephant5; 10% OFF Over $59, Code: Elephant10



MQ9 MQ-9 CO carbon monoxide combustible gas sensor detection alarm module

Regular price $3.50

Shipping calculated at checkout.

Introduction

Sensitive material MQ-9 gas sensor is used to clean the air in the lower conductivity of tin dioxide (SnO2). Detection method using low temperature cycling (1.5V heating ) to detect carbon monoxide, conductivity sensors with carbon monoxide in the air increased with increasing gas concentration , spurious adsorption at high temperatures (5.0V heating ) detection of combustible gases methane, propane and cryogenic cleaning gases. Simple circuit can be used to change the conductivity , concentration of the gas is converted to the corresponding output signal. MQ-9 high gas sensor for carbon monoxide, methane , liquefied petroleum gas sensitivity , the sensor can detect a variety of gases containing carbon monoxide and flammable , is a low-cost sensors for a variety of applications.

Module Application:

Can be used for home and factory gas leak monitoring device, suitable for liquefied gas, butane, propane, methane, smoke and other detection;

Features

1, the use of high-quality double-panel design, with power indicator and TTL signal output instructions;
2, with DO switch signal (TTL) output and AO analog signal output;
3, TTL output valid signal is low. (When the output low signal lights, can be directly connected to the microcontroller or relay module)
4, the analog output voltage with the higher the higher the voltage the higher the voltage.
5, the liquefied petroleum gas, natural gas, city gas, smoke has a better sensitivity.
6, there are four screw holes to facilitate positioning;
7, product dimensions: 32 (L) * 20 (W) * 22 (H)
8, with long service life and reliable stability
9, fast response to recovery features

performance

  • Input voltage: DC5V Power consumption (current): 150mA
  • DO output: TTL digital 0 and 1 (0.1 and 5V)
  • AO output: 0.1-0.3V (relatively no pollution), the maximum concentration of about 4V voltage
  • Special reminder: the sensor power, the need to preheat 20S or so, the measured data was stable, the sensor fever is a normal phenomenon, because the internal electric wire, if the hot is not normal.

Wiring:
1, VCC: then the power supply positive (5V)
2, GND: Connect the power supply negative
3, DO: TTL switch signal output
4, AO: analog signal output